Philips Domestic App. HR7723/00 HR7724/16 free download

File name food_processor_©_.pdf

Cucina Food processor HR7723/00 HR7724/16 Philips Domestic Appliances and Personal Care Service Manual PRODUCT INFORMATION - The food processors are equipped with mechanical and thermal safety switches. - Product meets the requirements regarding interference suppression on radio and TV. - After the product has been repaired, it should function properly and has to meet the safety requirements as laid down officially established at this moment. Automatic resettable cut-out (part of item 7) - To prevent damage due to overheating, the appliance has been equipped with an automatic cut-out system. This system will automatically cut off the power supply when the appliance overheats. If the appliance suddenly stops running: Unplug the appliance Set the knob to position 0 Let the appliance cool down for 15 minutes Plug the appliance in again Switch the appliance on again TECHNICAL INFORMATION - Motor power : HR7723 - 600 W HR7724 - 700 W Voltage : 230 V : 110 V Frequency : 50 / 60 Hz Colour : White Cordset : 125 cm Speed settings : 2 speeds + pulse Bowl capacity : 2.5 l dry ingredients 1.0 l liquids Blender capacity : 1.0 l liquids 2.0 l (max. contents) Speeds unloaded : blender drive shaft 17000 rpm (max) acc. drive shaft 2150 rpm (max) acc. drive shaft 1400 rpm (min) Weight in fancy box : HR7723/24 - 5100 g Dimensions : HR7723/24 - 420 x 280 x 360 (l x w x h) SAP coding : HR7723/00 HR7724/16 - Safety lock (item 1) - Place the lid on the bowl in the right position. The appliance will only function if the arrow on the applinace is directly opposite the mark on the lid of the food processor bowl and the same holds for the other accessoires. The built-in safety lock will now be deblocked and you can turn the appliance on. Note that if both the blender jar and the bowl have been correctly mounted, only the blender will function. Important: - If the appliance is used without the blender jar, the appliance will not function if the screw cap has not been screwed onto the attaching hole for the blender. Published by Philips Domestic Appliances and Personal Care Printed in the Netherlands © Copyright reserved Subject to modification 4322 277 01090 02/11 HR7723/00 / HR7724/16 DISASSEMBLY- AND RE-ASSEMBLY ADVISE - A separate drawing shows how to disconnect the speed selection knob. - The top housing (item 29) can be removed by detaching the snap connections by sticking a pin (or a screwdriver) through the small round holes (3 mm dia.) in the bottom plate (item 27) and the housing (item 12). The arrows in the drawing show the locations of the holes. - In order to replace the speed selection knob, the locking lever (item 33) must be placed in its lowest position. - The accessory drive shaft (item 15) has a locking piece (item 14). - The assembly of the accessories depends on the national version. - For specific versions, the component configuration may differ from the one shown on the exploded view. However, the actual components can be distinguished by the